Slag dryer is mainly composed of parts like rotary drum, ridding wheel, feeding and discharging devices, transmission part and gear cover, etc. The following content will discuss about some problems that need to be noticed when improving the output of slag dryer. The ventilating effect of dust remover can influence the output of slag dryer. If you want to have higher output, you’d better use a dust remover with relatively high wind volume. When hot air contacts with raw material, heat exchange occurs immediately. In order to make heat exchange occur rapidly and lower the temperature of exhaust gas, there must exist certain negative pressure in rotary drum, which can inhale hot air immediately.

The slag dryer is widely used for industries of cement, mining, building material, chemical engineering and fertilizer production, etc. In order to better control the temperature of slag dryer, we’ d better install thermocouples at the feeding mouth and discharging mouth. The temperature changes can fully reflect on the thermocouples, which offer the scientific support for raising or lowering temperature.

With the marketing principle that occupying market by products, creating market by service and leading market by popularity, Dingli has been making a lot of efforts to practice this marketing principle. By virtue of excellent products and perfect service, Dingli has established long-term cooperation with many enterprises. If you need our products, please click the website and leave messages on it: http://www.ft-dryer.com. We will contact with you as soon as possible. If you have any question about our products, leaving your advice on our website is also OK. We will take them sincerely. Thank you!