With the wide application of wood chips dryer, its performance is more and more attractive. To get the best performance of wood chip dryer, mastering the skill is necessary, and the correct operation can make the performance of wood chip dryer. Play to be better. Here are three basic tips for using.

  1. Before the wood chip dryer is turned on, check the connection of the power supply. The fixed position of the drum is correct. Connect the power supply, open the upper cover, turn on the motor switch, let the drum run idly, and the steering should be in the housing. The arrow pointing direction is the same, and the heating wire is turned on for 5 minutes. If there is still no hot air exhausted, stop it and check if the heating wire exhaust port is blocked.
  2. The lid should be put down during the drying work, and the workpiece should be stopped when loading and unloading. Note that the workpiece should be evenly distributed in the drum, otherwise the centrifugal force will not be parallel, so that the dehydration opportunity will be shaken violently. The workpiece of the drum can not be overloaded, and it should not be overfilled. If the dry workpiece is small in density or easy to store liquid, first centrifuge and dry for 1-2 minutes, take out the micro-turn, turn the workpiece to the position, and heat and centrifuge to achieve satisfactory Effect.
  3. To stop the drum, first stop the electric machine, then use the foot to brake the brake plate, but remember to turn off the motor to brake. The dryer can be separately centrifuged without heating, but the motor cannot be shut down and heated separately for drying.
  The above is a summary of some tips for using the sawdust dryer. For more information on the technical aspects of the dryer, you can contact us for advice.