In daily life, waste materials such as wood chips and sawdust can also be used after drying and processing. Among them, the most widely used is to make wood chips into charcoal after drying. This not only avoids the consumption of a large amount of wood, but also makes the waste material have higher use value, and the charcoal made from the dried wood chips has better flammability, less smoke, and very high market popularity. So which equipment is stable and reliable for drying wood chips? With so many types of drying equipment on the market, how should users choose?

  There are many wood chip dryers that can be used to dry sawdust, whether it is a box type, a mesh belt or a drum, but we must first understand the meaning of drying wood chips. After the wood chips are dried, they are used to make charcoal, so the drier the wood chips, the better, but the drier the wood chips, the higher the cost, so the wood chips must be dried to a certain level, usually about 11% can be used to make charcoal, so we can first filter out wood chips are dried to a moisture content of 11%, and the lowest cost equipment is sufficient. After comparing the heat sources and drying effects used by several devices, we can determine that the drum-type drying equipment is very suitable for drying wood chips. However, the tumble dryer has two structures, single-cylinder type and three-cylinder type, and both can meet the drying requirements of wood chips, and both have very obvious advantages. How to choose at this time? We can analyze the structural characteristics of the two types of equipment. Many people think that the three-cylinder structure is more suitable for drying wood chips. Indeed, the three-cylinder structure has good thermal insulation performance, small floor space and low drying cost, but there is an obvious disadvantage. The internal space is narrow and has an S-shaped trend. For materials with poor fluidity such as wet wood chips, it is very easy to block at the bends, and the internal sealing of the three-cylinder drying equipment is very good, and once a lot of blockage occurs , It is very difficult to solve, so only the use of single-cylinder drying equipment. It can be said that the single-cylinder drying equipment has great advantages for drying wood chips. First, the internal space of the equipment is large, which can accommodate more wood chips, and the output is greater. Secondly, there is no bending inside the equipment, and the wood chips can be driven by the lifting plate. The smooth flow to the end of the equipment improves the efficiency of wood chip drying. It can be seen that the single-tube structure is more suitable for drying wood chips.

  Through various comparisons, it is not difficult to see that the single-layer drum drying equipment for drying wood chips is more stable and reliable, and the structure of this equipment is simple, and if there are any problems in later use, it is also very convenient to maintain.